2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Disassembly

  1. Loosen the screw and then remove the paddle shift switch (A).
    G13540646Courtesy of HYUNDAI MOTOR AMERICA
    G13540647Courtesy of HYUNDAI MOTOR AMERICA
  2. Disconnect the paddle shift switch connector (A).
    G13540648Courtesy of HYUNDAI MOTOR AMERICA
    G13540649Courtesy of HYUNDAI MOTOR AMERICA
  3. Loosen the screw and then remove the remote control switch (A) and upper cover (B).
    G13540650Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the remote control switch connector (A).
    G13540651Courtesy of HYUNDAI MOTOR AMERICA
    G13540652Courtesy of HYUNDAI MOTOR AMERICA
  5. Loosen the screw and then remove the haptic motor (A).
    G13540653Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the wiring connector (A).
    G13540654Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the lower cover (A).
    G13540655Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the wiring (A) from the lower cover.
    G13540656Courtesy of HYUNDAI MOTOR AMERICA
  9. Reassembly in the reverse order of disassembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.