Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Terminal Function
| Pin No | Description |
|---|---|
| 1 | B + |
| 2 | Tilt sensor input |
| 3 | Tele sensor input |
| 4 | Tilit up switch input |
| 5 | Tele sensor input |
| 6 | CAN High |
| 7 | CAN Low |
| 8 | - |
| 9 | Tilt motor up output |
| 10 | Battery + |
| 11 | Tilt motor down output |
| 12 | IG 1 |
| 13 | Position sensor power output |
| 14 | - |
| 15 | Tilt down switch input |
| 16 | Tele bakcward direction switch input |
| 17 | - |
| 18 | Ground sensor |
| 19 | Ground |
| 20 | Ground power |
| 21 | Tele motor forward direction output |
| 22 | Tele motor backward direction output |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.