Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Adaptive Front Lighting System DTCS
ADAPTIVE FRONT LIGHTING SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B1101 | 17: Batt Voltage High |
| DTC B1102 | 16: Batt Voltage Low |
| DTC B1220 | 87: CAN Speed Sig fault |
| DTC B1301 | 87: CAN Steering angle Sig fault |
| DTC B1302 | 87: CAN Gearbox Sig fault |
| DTC B1304 | 87: CAN Eng speed Sig fault |
| DTC B1305 | 87: CAN Yaw rate Sig fault |
| DTC B1308 | 87: CAN H Lamp Sig Fault |
| DTC B1603 | 88: CAN 'Bus off fault |
| DTC B1621 | 01: ECU Hard Fault |
| DTC B1622 | 48: ECU Soft fault |
| DTC B1636 | 88: LIN fault Physical fault |
| DTC B1637 | 54: Sys Cal not performed |
| DTC B1639 | 81: LIN fault Communication error DBL Left |
| DTC B1661 | 46: Parameter missing |
| DTC B1953 | 03: Veh Level Sensor Fault |
| DTC B2200 | 81: LIN fault Communication error DBL Right |
| DTC B2201 | 81: LIN fault Communication error HLL Left |
| DTC B2202 | 81: LIN fault Communication error HLL Right |
| DTC B2325 | 09: Swivel Mod fault Left |
| DTC B2326 | 09: Swivel Mod fault Right |
| DTC B2400 | 09: Levelling Mod fault left |
| DTC B2401 | 09: Levelling Mod fault right |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
