2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Description And Operation: Description

Installed on the intercooler inlet pipe, the RCV (Recirculation Valve) Control Solenoid Valve operates the RCV actuator which controls the by-pass passage of the turbocharger compressor. When the throttle is closed with the engine running at cruise RPM (tip-out), the turbocharger boost pressure increases rapidly. The pressure wave strikes a compressor blades causing a knocking noise. To prevent this, the ECM opens the recirculation valve which allows excessive boost pressure to vent back to the air cleaner side of the turbocharger compressor.

G13539464Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.