Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Inspection
- Switch "OFF" the ignition.
- Disconnect the OTS connector.
- Remove the OTS.
- After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2.
- Check that the resistance is within the specification.
Temperature [Β°C (Β°F)] Resistance (kΞ©) -40 (-40) 52.15 -20 (-4) 16.25 0 (32) 6.0 20 (68) 2.45 40 (104) 1.11 60 (140) 0.54 80 (176) 0.29
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.