Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Removal
- Turn ignition switch OFF and disconnect the negative (-) battery cable.CAUTION:
- Wait at least 30 seconds after separating the cable.
- Separate the engine room relay block.
(Refer to Body Electrical System - "RELAY BOX (ENGINE COMPARTMENT) ")
- Disconnect the ESP connector (A).
- Loosen the ESP brake tube flare nuts (A), (B).
Tightening torque
- 16.7 - 20.6 N.m (1.7 - 2.1 kgf.m, 12.3 - 15.2 lb-ft)
- 20.6 - 24.5 N.m (2.1 - 2.5 kgf.m, 15.2 - 18.1 lb-ft)
- Loosen the ESP bracket bolts (A) and then remove the ESP.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.