Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Installation
- To install, reverse the removal procedure.
- After installation, bleed the brake system.
(Refer to Brake System - "BRAKE BLEEDING PROCEDURES ")
- Connect the GDS to the data link connector located underneath the dash panel.
- Using the GDS, Perform FCA (Smart cuise control system) variant coding.
- After replacing the ESP control module execute the "Assembly Check (ECU replacement)" of the additional function to check that the mounting is successful.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.