Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Driver Power Window Switch
CAUTION:
- Wrap the protective tape on the tool to disassemble with the screwdriver or remover.
- Use caution in keeping and handling during disassembling/assembling because it is easily contaminated with lubricant and oil.
- Use caution for the crash pad garnish and door trim upper garnish made of timber (Real wood) because they can be scratched or picked.
- Be careful not to scratch the door trim and other parts.
- Disconnect the negative (-) battery terminal.
- Remove the front door trim panel.
(Refer to Body - "FRONT DOOR TRIM ")
- Disconnect the DDM (Driver Door Module) connector (B) and then remove the power window switch (A).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.