2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Installation

  1. Install the steering wheel remote control switch after connecting the connector.
  2. Install the cover and install the steering wheel.
  3. Install the driver airbag module.
  4. Connect the negative (-) battery terminal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.