Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Genesis G70 2.0T Advanced, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Inspection: Notes
NOTE:
Steering Wheel Remote Control system (SWRC) can be diagnosed by GDS because it receives and sends signals through CAN communication.
- Check for resistance between terminals in each switch position (LH).
[Audio]
Switch Connector Terminal Resistance (±5%) SEEK UP 3-6 390 Ω SEEK DN 3-6 610 Ω Mode 3-6 910 Ω MUTE 3-6 1.38 kΩ Voice 3-6 2.13 kΩ END 3-6 3.68 kΩ SEND 3-6 8.58 kΩ - Check for resistance between terminals in each switch position (RH).
[Cruise]
| Switch | Connector Terminal | Resistance (± 5%) |
|---|---|---|
| CANCEL | 3-4 | 390 Ω |
| RES+ | 3-4 | 610 Ω |
| SET- | 3-4 | 910 Ω |
| Cruise ON/OFF | 3-4 | 1.38 kΩ |
| SLD | 3-4 | 2.13 kΩ |
| SCC | 3-4 | 3.63 kΩ |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
