2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

CAUTION:
  • When Diagnostic Trouble Codes (DTC) is on, perform the following procedure to replace it.
  • Automatic transmission is composed of delicate components. Be careful not to cause any damage on the component in the course of assembly and disassembly.
  • Maintain clean condition so that foreign substance does not get into the automatic transmission.
  • Use a coated apron, latex gloves, and stainless tray to prevent foreign substance from getting into the transmission.
  • Automatic transmission fluid (ATF) can be reused. Collect it using a clean 10-liter beaker.
  1. Place the vehicle on the lift and turn off the engine. Then, disconnect the battery (-) cable.
  2. Remove the undercover.

    (Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")

  3. Remove the E module connector (A).
    Fig 1: Removing E Module Connector
    G11404613Courtesy of HYUNDAI MOTOR AMERICA
  4. Perform automatic transmission fluid (ATF) drain and connect the drain plug.

    Tightening Torque:Β 

    22.6 - 24.5N.m (2.3 - 2.5 kgf.m, 16.6 - 18.1 lb-ft)

    Fig 2: Draining Automatic Transmission Fluid
    G11404614Courtesy of HYUNDAI MOTOR AMERICA
  5. Unscrew all oil fan mounting bolts except for the edge bolts (A).

    Tightening Torque:Β 

    9.8 - 11.8N.m (1.0 - 1.2 kgf.m, 7.2 - 8.2 lb-ft)

    Fig 3: Locating Oil Fan Mounting Bolts
    G11404615Courtesy of HYUNDAI MOTOR AMERICA
  6. Fix it to the bottom of the oil fan using a jack (B) and unscrew two edge bolts (A). Then, remove the oil fan.
    NOTE:
    • Disconnect the oil fan (C) on the oil filter side and remove it.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.