2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

  1. Check signal waveform of output speed sensor using the GDS.

    Specification  : Refer to "Signal Waveform" chart below.

    f< 1000Hz D
    G11404610
    R
    G11404611
    f > 1000Hz D
    R
    G11404612
    Pulse
    Width
    t1(D): 60μs (50 - 70us)
    t2(R): 120μs (102 - 138us)
    t3: 30μs (24 - 36us)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.