Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE
Recall by Memory & Position Switch
When the manual operation is not carried out
- The current position is saved when memory position command is received.
- Memorization permission
- Enables CAN signal memory.
- Memorization
- When the SCM receives a CAN signal for memory position command, it saves the current tilt and telescope position.
- Precautions during memorization
- Memorized data must remain intact even if the battery is removed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
