2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE

Error Detection

  1. Error detection for tilt and telescope
    • SCM detects an error if the following conditions occur during reproduction, driver in/out operation, or operation by manual switch.
    • Error generation conditions
    • Tilt: Less than 4 pulses within 1 sec.
    • Telescope: Less than 4 pulses within 1 sec.
    • Error clear conditions
    • Tilt: Over 4 pulses within 1 sec.
    • Telescope: Over 4 pulses within 1 sec.
  2. Operation when an error is detected
    • Tilt & Telescope operation stops regardless if the operation was manual, reproduction or driver in/out operation.

      But position operations other than that of the motor with an error are performed normally.

    • When the manual switch is switched from OFF to ON, the motor moves to the position intended by the driver even if an error has occurred.
    • If reproduction or driver in/out operation conditions are satisfied, then all the motors move to the target positions. But the motor with an error moves to the target position only after clearing the error.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.