Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE
Multi-View Camera System DTCS
MULTI-VIEW CAMERA SYSTEM DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B103000 | No Camera Tolerance Correction |
| DTC B161A00 | AVM Internal Trouble |
| DTC B162C00 | Camera Power Line Short |
| DTC B16B700 | Front Camera Input Error |
| DTC B16B800 | Rear Camera Input Error |
| DTC B16B900 | Left Camera Input Error |
| DTC B16BA00 | Right Camera Input Error |
| DTC C161600 | C-CAN Bus OFF |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
