Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Inspection: Notes
WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Steering Wheel Remote Control system (SWRC) can be diagnosed by GDS because it receives and sends signals through CAN communication.
- Check for resistance between terminals in each switch position (LH).
[Audio]
Switch Connector Terminal Resistance Ω (±5%) Speech Recognition 6~8 18.81kΩ SEEK UP 6~8 4.51kΩ SEEK DN 6~8 2.11k Ω Mode 6~8 6.71k Ω SEND 6~8 430 Ω END 6~8 1.11k Ω MUTE 1~8 0 VOL UP 2~3 - VOL DN 2~3 - - Check for resistance between terminals in each switch position (RH).
[Cruise]
| Switch | Connector Terminal | Resistance Ω (±5%) |
|---|---|---|
| CANCEL | 2~3 | 180Ω |
| RES+ | 2~3 | 550Ω |
| SET- | 2~3 | 330Ω |
| Cruise ON/OFF | 2~3 | 880Ω |
| Space between cars | 2~3 | 2.54k Ω |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
