2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  1. Put on gloves before removing/installing the drive unit.
  2. Do not install or carry a push rod, controller and wire harnesses by holding it with bare hands.
  3. Be careful when removing the push rod, the trunk may close.
  1. Disconnect the negative (-) battery terminal.
  2. Remove the left trunk trim after opening the trunk.

    (Refer to TRUNK TRIM Body )

  3. Separate the power trunk module push rod pin (A) and then remove the power trunk module connecting rod (B).
    G11342488Courtesy of
  4. Remove the power trunk module & drive unit (A) after disconnecting the connector, bolts and nuts.
    G11342489Courtesy of
  5. Remove the power trunk module (A) after loosening the mounting screws.
    G11342490Courtesy of
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.