2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection: Notes

WARNING: This page is about a different car, the 2017 Genesis G80. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the power latch and cinching connectors.
    G11342497Courtesy of
  2. Connect the power latch terminals directly to battery voltage (12V) and check that the motor operates smoothly.
    G11342498Courtesy of
    G11342499Courtesy of
  3. Connect the power cinching terminals directly to battery voltage (12V) and check that the motor operates smoothly.
G11342500Courtesy of
G11342501Courtesy of
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.