2017 Genesis G90 3.3T Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Inspection

If idle RPM is unstable or engine stops, check the ETC module operation with GDS diagnostic tool.

And if necessary, clean carbon in the throttle body.

  1. Connect the GDS to the Data Link Connector (DLC).
  2. Select "Vehicle S/W management" β†’ "Inspection/Test" β†’ "ETC Performance Test" on the GDS menu.
  3. Perform "ETC module test" procedure in accordance with the message.
    Fig 1: Screen Display - ETC Module Test Preparation
    G11412131Courtesy of HYUNDAI MOTOR AMERICA
  4. If the test result of the ETC module or TPS signal shows NG, perform ETC module cleaning.
Fig 2: Screen Display - ETC Performance Test Results
G11412132Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.