Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Genesis G80 3.8 Premium, AWDFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Installation
- Install the inhibitor switch. When installing, tighten the inhibitor assembly mounting bolts (A) loosely to allow any necessary adjustments to be made.
- Install the manual control lever (A).
- Tighten the nut (B) to the specified torque.
Tightening torque:Β
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
- Install the SST (09480-A3800) or 0.1969in. (5mm) bolt after setting manual control lever (A) in the "N".
- Tighten the bolts (A) to the specified torque.
Tightening torque:Β
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
- Remove the SST (09480-A3800) or 0.1969in. (5mm) bolt.
- Install the shift cable and tighten the mounting nut (A).
- Connect the inhibitor switch connector (B).
Tightening torque:Β
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
NOTE: Adjust the shift cable before tightening the nut.
(Refer to Automatic Transmission Control System - "SHIFT CABLEΒ ") - Connect the negative (-) battery cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
