Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Genesis G80 3.8 Premium, AWDFACTORY OEM SERVICE PROCEDURE
Occupant Classification DTCS
OCCUPANT CLASSIFICATION DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B111117 | Ignition Voltage High |
| DTC B111216 | Ignition Voltage Low |
| DTC B160388 | CAN BUS OFF |
| DTC B169787 | ACU Communication Error |
| DTC B176300 | OCS ECU Defect |
| DTC B176400 | OCS MAT Defect |
| DTC B17672F | OCS Algo Cut Off |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
