Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Genesis G80 3.8 Premium, AWDFACTORY OEM SERVICE PROCEDURE
Cluster Module DTCS
CLUSTER MODULE DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B100051 | EOL Not Programmed |
| DTC B100152 | SCC Missing Error - without SCC unit or connector fault |
| DTC B100155 | SCC Present Error - Coding code error |
| DTC B100252 | EPB Missing Error |
| DTC B100255 | EPB Present Error |
| DTC B100352 | ABS Missing Error - without ABS unit or connector fault |
| DTC B100355 | ABS Present Error - Coding code error |
| DTC B100552 | Airbag Missing Error - without Airbag unit or connector fault |
| DTC B100555 | Airbag Present Error - Coding code error |
| DTC B100652 | PSB Missing Error - without PSB unit or connector fault |
| DTC B100655 | PSB Present Error - Coding code error |
| DTC B100852 | MDPS Missing Error |
| DTC B100855 | MDPS Present Error |
| DTC B101052 | ESC Missing Error |
| DTC B101055 | ESC Present Error |
| DTC B102052 | TPMS Missing Error |
| DTC B102055 | TPMS Present Error |
| DTC B104052 | LKAS/LDWS Missing Error - without LKAS/LDWS unit or connector fault |
| DTC B104055 | LKAS/LDWS Present Error - Coding code error |
| DTC B108052 | ECS Missing Error - without ECS unit or connector fault |
| DTC B108055 | ECC Present Error - Coding code error |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
