2017 Genesis G80 3.8 Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the air cleaner assembly.

    (Refer to INTAKE & EXHAUST SYSTEM - 3.8L Engine Mechanical System )

  3. Remove the delivery pipe and injector.

    (Refer to Fuel Delivery System - "DELIVERY PIPE ")

  4. Disconnect the connector (A), and then remove the CVVT oil temperature sensor (B).
G11355057Courtesy of
NOTE:
  • When removing and installing the oil temperature sensor, use a deep socket as shown in illustration below.
  • 3/8" drive deep socket (24mm) with the thin wall and the length less than 75mm.
G11355058Courtesy of

[Arrangement of tools for removing oil temperature sensor] 

G11355059Courtesy of

[Installation order for tools] 

  1. Insert a 24 mm (0.94 in.) deep socket (A) to the oil temperature sensor.
    G11355060Courtesy of
  2. After connecting other tools as arranged in the above image, insert the tools (A) to socket.
G11355061Courtesy of
Chapter Navigation
Return to Chapter: Repair Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.