2017 Genesis G80 3.8 Premium, AWDFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

[CVVT Oil Control Valve (Intake)] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold.

    (Refer to INTAKE & EXHAUST SYSTEM - 3.8L Engine Mechanical System )

  3. Disconnect the CVVT oil control valve connector (A).
  4. Remove the installation bolt (B), and then remove the valve from the engine.

    [Bank 1] 

    G11355099Courtesy of

    [Bank 2] 

    G11355100Courtesy of

[CVVT Oil Control Valve (Exhaust)] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the CVVT oil control valve connector (A).

    [Bank 1] 

    G11355101Courtesy of

    [Bank 2] 

    G11355102Courtesy of
  3. Remove the cylinder head cover.

    (Refer to CYLINDER HEAD ASSEMBLY - 3.8L Engine Mechanical System )

  4. Remove the installation bolt (A), and then remove the valve from the engine.

    [Bank 1] 

    G11355103Courtesy of

    [Bank 2] 

    G11355104Courtesy of
Chapter Navigation
Return to Chapter: Repair Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.