Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Programing an Existing or New Control Module
To program a replacement or an existing B174W Frontview Camera - Windshield, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield Configuration and follow the on-screen instructions.
- Clear DTCs
- Following B174W Frontview Camera - Windshield replacement and/or reprogramming, the module must be calibrated. Refer to Front View Camera Module Learn .
After programming, a current DTC may be set in the B174W Frontview Camera - Windshield that is unable to be cleared. This is normal and an indicator that the B174W Frontview Camera - Windshield is in learn mode.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.