Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 GMC Canyon AT4FACTORY OEM SERVICE PROCEDURE
Setup for Component Replacement - Fuel Pump Driver Control Module Configuration/Fuel Pump Power Control Module Configuration
- Ignition - On / Vehicle - In Service Mode - For 2 min
- Ignition/Vehicle - Off - For 2 min
- Ignition - On / Vehicle - In Service Mode
- Perform the following action: Clear the DTCs.
- Start Engine
- Verify DTC P1005 is not set.
- If the DTC sets
- Perform the following action: Clear the DTCs.
- Ignition/Vehicle - Off - For 2 min
- Start Engine
- Verify the DTC does not set.
- If the DTC sets - Repeat the procedure starting at step 1
- If the DTC is not set - Configuration - Complete
- Go to next step: If the DTC is not set
- Configuration - Complete
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.