Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 GMC Canyon AT4FACTORY OEM SERVICE PROCEDURE
Ignition Coil: Remove & Replace
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 2.7L Eng, All Four | 1.4 | 1.1 | C | |
| 2.7L Eng, One,#1,2 or 3 | 0.4 | C | ||
| 2.7L Eng, One,#4 | 1.1 | C | ||
| Combination Procedure: IGNITION COIL BOOTS: Remove & Replace: | ||||
| 2.7L Eng, One or All | 0.1 | C | ||
| Combination Procedure: SPARK PLUG TUBE SEAL: Remove & Replace: | ||||
| 2.7L Eng, Camshaft Carrier,Gasket | 8.0 | C | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.