2021 GMC Terrain SLFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2021 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM4853559Courtesy of GENERAL MOTORS COMPANY

    Cruise Control Switch (1) - Install

  2. GM4853650Courtesy of GENERAL MOTORS COMPANY

    Connect electrical connection (1).

  3. GM4806693Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Cruise control switch screw (1) - Install and tighten 2.5 N.m (2 lb/in)

  4. GM4806246Courtesy of GENERAL MOTORS COMPANY

    Steering Wheel Shroud (1) - Install

  5. GM4806049Courtesy of GENERAL MOTORS COMPANY

    Steering Wheel (2) - Install - Steering Wheel Replacement

  6. GM4806796Courtesy of GENERAL MOTORS COMPANY

    Steering Wheel Airbag (1) - Install - Steering Wheel Airbag Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.