Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 GMC Sierra 3500 HD SLT, 6.6L Eng VIN 7, 4WDFACTORY OEM SERVICE PROCEDURE
Programming an Existing Control Module
- Ignition - On / Vehicle - In Service Mode
- Access SPS and follow the on-screen instructions for the control module: K69 Transfer Case Control Module
- Perform the SPS function: K69 Transfer Case Control Module - Prepare Control Module for Removal
- Perform the SPS function: K69 Transfer Case Control Module - Programming
- Perform the SPS function: K69 Transfer Case Control Module - Setup
Verify the Transfer Case Clutch Identifier is auto populated correctly, if incorrect enter the correct Transfer Case Clutch Identifier.
Refer to: Transfer Case Identification
- Clear DTCs.
- Perform the scan tool function: Range Actuator Learn
Refer to: Transfer Case Range Actuator Learn
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
