2021 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE

Accessory AC and DC Power Control Module Bracket Replacement

WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
GM4420167Courtesy of GENERAL MOTORS COMPANY
Callout Component Name

Preliminary Procedures

  1. Disconnect the negative battery cable. Battery Negative Cable Disconnection and Connection
  2. Front Floor Console Rear Trim Panel Replacement (GMC with Rear Vent) , or Front Floor Console Rear Trim Panel Replacement (GMC with Auxiliary Heater and AC Control)
  3. Reposition the carpet, if necessary.
1 Accessory AC and DC Power Control Module Bolt [2x]
Tighten 
2.5 N.m (22 lb in)
2 Accessory AC and DC Power Control Module Bracket

Procedure

  1. Disconnect the electrical connector.
  2. Transfer components as necessary.
  3. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.