Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Reprogram Control Module
To reprogram an existing K20 Engine Control Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- Perform one of the following SPS Programming functions:
- K20/K71 Engine and Transmission Control Modules and follow the on-screen instructions.
- K20 Engine Control Module and follow on-screen instructions.
NOTE:If both controller options below are listed, select K20/K71 Engine and Transmission Control Modules.
- Clear DTCs after completing the Programming procedure.
If vehicle fails to start during Configuration and Setup, perform the SPS Function Immobilizer Learn and follow the on-screen instructions.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.