Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 GMC Terrain SLFACTORY OEM SERVICE PROCEDURE
Unsuccessful Programming Recovery
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ensure the EL-52100 is used when programming the vehicle.
In the event of an interrupted or unsuccessful programming event, perform the following steps:
- Verify the K56 Serial Data Gateway Module, X84 Data Link Connector, and programming tool connections are secure and the SPS software is up to date.
- Ignition/Vehicle OFF.
- Access SPS and follow the on-screen instructions for the K56 Serial Data Gateway Module.
- Verify the K56 Serial Data Gateway Module can be reprogrammed.
- If the K56 Serial Data Gateway Module cannot be reprogrammed
- Ignition/Vehicle OFF for greater than 1 min.
- Access SPS and follow the on-screen instructions for the K56 Serial Data Gateway Module.
- Verify the K56 Serial Data Gateway Module can be reprogrammed.
- If the K56 Serial Data Gateway Module cannot be reprogrammed, replace the K56 Serial Data Gateway Module.
- Go to next step: If the K56 Serial Data Gateway Module can be reprogrammed.
- All OK.
- Go to next step: If the K56 Serial Data Gateway Module can be reprogrammed
- All OK.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
