2018 GMC Terrain SLFACTORY OEM SERVICE PROCEDURE

Circuit/System Verification

Symptom Byte: 43, 45, 46, 47, 4A, or 5A

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC C056E is not set.
    • If the DTC is set 
    1. Perform all necessary programming and setup procedures for the control module: K43 Power Steering Control Module
    2. Verify the DTC does not set.
      • If the DTC sets - Replace the component: K43 Power Steering Control Module
      • If the DTC is not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.

Symptom Byte: 42

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC C056E is not set.
    • If the DTC is set 
    1. Calibrate the power steering control module. Refer to: Power Steering Control Module Calibration 
    2. Verify the DTC does not set.
      • If the DTC sets - Replace the component: K43 Power Steering Control Module
      • If the DTC is not set
    3. All OK.
    • Go to next step: If the DTC is not set 
  3. All OK.

Symptom Byte: 37

  1. Ignition - On/Vehicle - In Service Mode
  2. Verify DTC C056E is not set.
    • If the DTC is set 

      Replace the component: Steering Gear

    • Go to next step: If the DTC is not set 
  3. All OK.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.