Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
- Operate the vehicle within the Conditions for Running the DTC. Verify the DTC does not set.
- If the DTC sets
- Ignition/Vehicle - Off
- Verify the following conditions do not exist: Steering = Binding or Sticking
- If a condition exists - Refer to: Steering Effort Hard or Too Easy in One or Both Directions
- If no condition exists - Replace the component: Steering Gear
- Go to next step: If the DTC is not set
- All OK.
A DTC may set depending on certain driving conditions and would not require a component replacement. Aggressive steering may cause reduced steering assist. Discuss with the customer about the driving conditions when the concern occurred.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.