2018 GMC Terrain SLFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Inspect Bottom Of Fuel Pump Module For Green Rubber Pads
    GM4933870Courtesy of GENERAL MOTORS COMPANY
  1. Inspect bottom of fuel pump module for 3 green rubber pads (1). If rubber pads are present, remove and discard them from fuel pump module prior to installing the fuel pump module in the tank.
  2. Fig 2: Fuel Tank Fuel Pump Module And O-Ring
    GM4596023Courtesy of GENERAL MOTORS COMPANY
  3. Install New O-Ring (2)
  4. Install Fuel Tank Fuel Pump Module (1)
  5. Fig 3: Electrical Connector, Electrical Connector And Transfer Hose
    GM4596025Courtesy of GENERAL MOTORS COMPANY
  6. Connect Fuel Tank Vent Hose (3) - Plastic Collar Quick Connect Fitting Service 
  7. Connect Transfer Hose (2) - Plastic Collar Quick Connect Fitting Service 
  8. Connect Electrical Connector (1)
  9. Fig 4: Fuel Pump Lock Ring
    GM4596021Courtesy of GENERAL MOTORS COMPANY
  10. Install Fuel Pump Lock Ring (1) CH 52075  Fuel Sender Lock Ring Wrench
  11. Fig 5: Electrical Connector And Evaporative Emission Canister Vent Hose
    GM4596020Courtesy of GENERAL MOTORS COMPANY
  12. Connect Fuel Pump Fuel Feed Hose (4) - Plastic Collar Quick Connect Fitting Service 
  13. Connect Fuel Tank Vent Hose (3) - Plastic Collar Quick Connect Fitting Service 
  14. Connect Evaporative Emission Canister Vent Hose (2) - Plastic Collar Quick Connect Fitting Service 
  15. Connect Electrical Connector (1)
  16. Install Fuel Tank - Fuel Tank Replacement (AWD) 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.