2018 GMC Terrain SLFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Wireless Charging System Module
    GM4728239Courtesy of GENERAL MOTORS COMPANY
  1. Install Wireless Charging System Module
  2. Install Wireless Charging System Module Bracket Bolt (1) and tighten [4x] 1 N.m (9 lb in)
    CAUTION: Fastener Caution
    3. Fig 2: Front Floor Lower Console Bolt And Bolt Wireless Charging System Module
    GM4728235Courtesy of GENERAL MOTORS COMPANY
  3. Connect the electrical connector.
  4. Install Wireless Charging System Module Bracket (2) and Wireless Charging System Module (3).
  5. Install Front Floor Lower Console Bolt (1) and tighten [4x] 2.5 N.m (22 lb in)
    6. Fig 3: Front Floor Console Trim Plate
    GM4742076Courtesy of GENERAL MOTORS COMPANY
  6. Install Front Floor Console Trim Plate (1) -Front Floor Console Trim Plate Replacement (Terrain)
Chapter Navigation
Return to Chapter: Wireless Charging System Module Replacement (Terrain)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.