Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 GMC Canyon SLFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
Alignment Condition: Full tank of fuel, no passengers and placed on flat level surface.
| Front Suspension Wheel Alignment Service at Curb |
||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| Model | RPO Restriction | Caster ± 1.0° |
Cross Caster ± 1.0° |
Camber ± 0.8° |
Cross Camber ± 0.8° |
Total Toe ± 0.2° |
Steering Wheel Angle ± 3.0° |
Thrust Angle ± 0.4° |
||
| Left | Right | (Left - Right) | Left | Right | (Left - Right) | (Left + Right) | (Left - Right)/2 | |||
| All | All | 2.8° | 2.8° | 0.00° | -0.10° | -0.10° | 0.0° | 0.10° | -1.0° | 0.0° |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.