2018 GMC Canyon SLFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Spare Tire - Remove
  3. GM4556989Courtesy of GENERAL MOTORS COMPANY

    Electrical Connector (1) - Disconnect

  4. GM4556990Courtesy of GENERAL MOTORS COMPANY

    Trailer Brake Power Control Module Nut (1) - Remove [2x]

  5. GM4556992Courtesy of GENERAL MOTORS COMPANY

    Trailer Brake Power Control Module (1) - Remove

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.