2018 GMC Canyon SLFACTORY OEM SERVICE PROCEDURE

Installation Procedure

  1. GM4500356Courtesy of GENERAL MOTORS COMPANY

    Trailer Brake Control Switch (1) - Install

  2. GM4500355Courtesy of GENERAL MOTORS COMPANY

    Trailer Brake Control Switch Lever (1) - Install [2x]

  3. Electrical Connector - Connect
  4. GM4500354Courtesy of GENERAL MOTORS COMPANY

    Instrument Panel Compartment Toll Card Holder (1) - Install

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.