2018 GMC Canyon SLFACTORY OEM SERVICE PROCEDURE

Body Control Module Replacement

GM3725689Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Instrument Panel Knee Bolster Replacement
1 Body Control Module

Procedure

  1. Disconnect all electrical connectors.
  2. Press on the tabs to release the body control module from the bracket.
  3. Perform the necessary programming and setup procedure:Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.