Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE
Circuit/System Verification
- Ignition ON/Vehicle in Service Mode.
- Verify the scan tool Brake Transmission Shift Interlock Solenoid Actuator Command parameter changes from Inactive to Active when the brake pedal is applied.
- If the Brake Transmission Shift Interlock Solenoid Actuator Command does not change
Refer to Stop Lamps Malfunction .
- Go to next step: If the Brake Transmission Shift Interlock Solenoid Actuator Command changes
- If the Brake Transmission Shift Interlock Solenoid Actuator Command does not change
- Verify the S3 Transmission Shift Lever moves out of the PARK position when the brake pedal is applied.
- If the S3 Transmission Shift Lever does not move out of the PARK position
Refer to Circuit/System Testing.
- Go to next step: If the S3 Transmission Shift Lever does move out of the PARK position
All OK.
- If the S3 Transmission Shift Lever does not move out of the PARK position
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
