2018 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE

Front View Driver Information Camera Bracket Replacement

WARNING: This page is about a different car, the 2017 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front View Driver Information Camera Bracket
GM4378918Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Front View Camera. Refer to Front View Camera Replacement 
1 Front View Driver Information Camera Bracket

Procedure

  1. Release the retaining tabs and slide the bracket upward to disengage pins, gently pull from windshield
  2. Ensure the inside of the windshield is clean before reinstalling the bracket.
NOTE:

Do Not remove or service the sensor farm pins.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.