2018 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE

Oil Pump Flow Control Valve Replacement

GM4174366
Callout Component Name
Preliminary Procedure 
Oil Pump Flow Control Valve Heat Shield Replacement 
1 Oil Pump Flow Control Solenoid Valve Electrical Connector
2 Oil Pump Flow Control Valve Fastener
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
3 Oil Pump Flow Control Valve
Procedure 
Install a NEW O-ring seal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.