2018 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE

Fuel Injector Replacement

Special Tools

  • EN-47909  Injector Bore and Sleeve Cleaning Kit
  • EN-49245  Fuel Injector Seal Installer and Sizer
  • EN-50791  Fuel Injector Nozzle Installer
  • EN-51105  Fuel Injector Seal Installer

Equivalent regional tools: Special Tools

CAUTION:

Use care in removing the fuel injectors in order to prevent damage to the fuel injector electrical connector pins or the fuel injector nozzles. Do not immerse the fuel injector in any type of cleaner. The fuel injector is an electrical component and may be damaged by this cleaning method.

  1. Fuel Injection Fuel Rail - Remove - Fuel Injection Fuel Rail Assembly Replacement 
  2. GM2836381

    Remove and inspect the fuel rail insulator assemblies (1 - 4). Replace the entire assembly if any components show signs of wear or the insulators (4) show the following conditions:

    • Dry or cracked appearance
    • Flattened or misshapen appearance
  3. GM2742603

    Disconnect the electrical connectors from the fuel injectors.

  4. Use the EN-50791  installer (3) to compress the fuel injector (1) and relieve pressure on the retaining pin (2). Remove the fuel injector retaining pin (2). Remove the EN-50791  installer once the retaining pin is removed.
  5. GM2742599
    NOTE:
    • Support the fuel injector at the widest point.
    • Support the fuel injection fuel rail along the bottom.
    • Do NOT support or hold the fuel injector by the tip or connector.
    • Do NOT tilt or excessively twist the fuel injector during removal.

    Remove the fuel injector (1) from the fuel injection fuel rail by pulling it straight out along the fuel injector axis. Slight rotation of the fuel injector is acceptable as long as excessive force is not applied to the fuel injector tab while engaged in the fuel rail slot (3).

  6. Remove the fuel injector holding clamp (2) from the rear of the fuel injector.
  7. GM2742600

    Remove and DISCARD the fuel injector O-ring (2) and spacer (1).

  8. Remove and DISCARD the fuel injector seals (3).
  9. GM2742601
    NOTE:

    Do NOT soak or submerge the fuel injection fuel rail or the fuel injectors in solvent. Do NOT use solvent on the fuel rail label.

    Clean the exterior of the fuel injection fuel rail (1) and the fuel injectors in solvent.

  10. Use the EN-47909  cleaning kit to clean the fuel injector bores and sleeves.
  11. Inspect the fuel injection fuel rail and components for the following conditions:
    • Damage, debris, or restrictions to the fuel rail
    • Damage, debris, or restrictions to the fuel ports in the fuel rail
    • Damage to the mounting area for the fuel rail
    • Damage to the fuel rail mounting bolts
    • Damage to the threads on the fuel rail fuel feed fitting
  12. Replace the fuel injection fuel rail if ANY damage is found. Do NOT attempt to repair a fuel rail.
  13. CAUTION:

    Refer to Fastener Caution .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.