2017 GMC Terrain SL, GasFACTORY OEM SERVICE PROCEDURE

Fastener Specifications

Single Use Non-Threaded Fasteners/Components

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application
Power Steering Assist Motor Seal
Power Steering Fluid Cooling Pipe Seal
Power Steering Gear Inlet Hose Seal
Power Steering Pump Fluid Reservoir Seal
Steering Gear Boot Inner Clamp
Steering Gear Pipe Seal
Steering Linkage Inner Tie Rod Washer
Single Use Threaded Fastener/Component Tightening Specifications

NOTE:

All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal.Β 

Application Specification
Metric (English)
Power Steering Assist Motor Bolt 8 N.m (71 lb in)
Steering Gear Bolt 110 N.m (81 lb ft)
Reusable Threaded Fastener Tightening Specifications

NOTE:

All fasteners listed in this table can be reused after removal.Β 

Application Specification
Metric (English)
Power Steering Fluid Cooling Pipe Bolt 9 N.m (80 lb in)
Power Steering Fluid Cooling Pipe Fitting 34 N.m (25 lb ft)
Power Steering Fluid Cooling Pipe Nut 9 N.m (80 lb in)
Power Steering Fluid Reservoir Bolt 9 N.m (80 lb in)
Power Steering Fluid Reservoir Nut 9 N.m (80 lb in)
Power Steering Gear Inlet Hose Fitting 34 N.m (25 lb ft)
Power Steering Pump Bolt 22 N.m (16 lb ft)
Steering Gear Heat Shield Bolt 9 N.m (80 lb in)
Steering Gear Pipe Fitting 16 N.m (12 lb ft)
Steering Linkage Inner Tie Rod 105 N.m (77 lb ft)
Steering Linkage Outer Tie Rod
  • First Pass:
25 N.m (18 lb ft)
  • Final Pass:
80 - 100 degrees
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.