2017 GMC Terrain SL, GasFACTORY OEM SERVICE PROCEDURE

Fuel Pump Power Control Module Replacement

Fig 1: Fuel Pump Power Control Module
GM2898971Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
1 Fuel Pump Power Control Module Fasteners (Qty: 2)
CAUTION:

Refer to Fastener Caution


Tighten 
8 N.m (71 lb in)
2 Fuel Pump Power Control Module

Procedure

  1. Open the spare tire compartment lid.
  2. Disconnect the electrical connector.
  3. If replacing, reprogram the module. Refer to Control Module References
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.