Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE
Technical Bulletins: Campaigns
- Accessories Control Systems
- N172097060 Side Blind Zone Alert Module Water Intrusion (N172097060)
- Vehicle Communication Interface Module (VCIM) Programming Not Completed (17398)
- Day Night Modes Incorrect (17178)
- 17056 - Loss Of Seat Belt Chime (17056)
- 17137 - Battery Negative Cable Nut Under-Torqued (17137-01)
- 16158 - Rearview Camera Image Reversed (16158)
- 60110 - Driver Mode Switch Inoperative (60110)
- Air Bag, SRS
- Anti-Lock Brakes
- Anti-Theft Systems
- Automatic Trans
- Auxiliary Emission Control Systems
- Axle Shafts
- Body Electrical
- Brakes Control Systems
- Collision/Avoidance
- Communication Devices
- Differentials & Drive Axles
- Driveshaft & Universal Joints
- Engine Control Systems
- Entertainment Systems
- Exterior Body Panels
- Exterior Lights
- Frames, Subframes & Crossmembers
- Fuel System
- Gauges & Instrument Panels
- HVAC Control Systems
- Ignition Switch/Steering Lock
- Interior/Exterior Trim
- Interior/Illumination Lights
- Mechanical
- Mechanical - Hydraulic
- Restraints Control Systems
- Seats
- Starter
- Suspension Control Systems
- Transfer Case
- Transmission Control Systems
- Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
