Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE
Symptoms - Object Detection: Notes
WARNING: This page is about a different car, the 2017 Cadillac ATS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following steps must be completed before using the symptom tables:
- Perform the Diagnostic System Check - Vehicle
before using the Symptom Tables in order to verify that all of the following are true:
- There are no DTCs set.
- The control modules can communicate via the serial data link.
Note: The rear vision camera does not communicate on the serial data bus.
- Review the system operation in order to familiarize yourself with the system functions. Refer to:
- Adaptive Cruise Control Description and Operation (with Adaptive Cruise Control, KSG, N America) Adaptive Cruise Control Description and Operation (with Adaptive Cruise Control, KSG, except N America)
- Active Safety System Description and Operation (with Active Safety System, UGN, except N America) Active Safety System Description and Operation (with Active Safety System, UGN, N America)
- Active Safety Seat Description and Operation
- Cross Traffic Alert Description and Operation
- Forward Collision Alert Description and Operation
- Lane Departure Warning Description and Operation
- Parking Assist Description and Operation (with Rear Park Assist, UD7) Parking Assist Description and Operation (with Front and Rear Park Assist, UD5)
- Rear Vision Camera Description and Operation
- Side Blind Zone Alert Description and Operation
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
