2017 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE

Manifold Absolute Pressure Sensor Replacement

Fig 1: Manifold Absolute Pressure Sensor
GM4375647Courtesy of GENERAL MOTORS COMPANY
Callout Component Name
Preliminary Procedure 
Remove Air Cleaner Outlet Duct. Refer to Air Cleaner Outlet Duct Replacement 
1 Electrical Connector
2 Manifold Absolute Pressure Sensor Bolt
CAUTION:

Refer to Fastener Caution .


Tighten 
5 N.m (44 lb in)
3 Manifold Absolute Pressure Sensor
NOTE:

Inspect the manifold absolute pressure (MAP) sensor O-ring seal and replace as necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.