2017 GMC Acadia SLFACTORY OEM SERVICE PROCEDURE

Fuel Injector Replacement

Special Tools

  • EN-47909  Injector Bore and Sleeve Cleaning Kit
  • EN-49245  Fuel Injector Seal Installer and Sizer
  • EN-50791  Fuel Injector Nozzle Installer
  • EN-51105  Fuel Injector Seal Installer

Equivalent regional tools: Special Tools

CAUTION:

Use care in removing the fuel injectors in order to prevent damage to the fuel injector electrical connector pins or the fuel injector nozzles. Do not immerse the fuel injector in any type of cleaner. The fuel injector is an electrical component and may be damaged by this cleaning method.

  1. Remove Fuel Injection Fuel Rail. Refer to Fuel Injection Fuel Rail Assembly Replacement 
  2. Fig 1: Fuel Rail Insulator Assemblies
    GM2836381Courtesy of GENERAL MOTORS COMPANY
  3. Remove and inspect the fuel rail insulator assemblies (1-4). Replace the entire assembly if any components show signs of wear or the insulators (4) show the following conditions:
    • Dry or cracked appearance
    • Flattened or misshapen appearance
  4. Fig 2: Fuel Injector, Installer And Retaining Pin
    GM2742603Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the electrical connectors from the fuel injectors.
  6. Use the EN-50791  installer (3) to compress the fuel injector (1) and relieve pressure on the retaining pin (2). Remove the fuel injector retaining pin (2). Remove the EN-50791  installer once the retaining pin is removed.
  7. Fig 3: Injectors, Holding Clamp And Fuel Rail Slot
    GM2742599Courtesy of GENERAL MOTORS COMPANY
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.